
This is Medicube's core patented technology, which other brands do not possess.
Booster Mode
Booster mode enhances the absorption of active ingredients. lt allows skincare actives to be applied more effectively, helping to boost overall glow and skin vitality.
The information above is intended to describe general technologies.
Airshot Mode
Airshot mode helps to improve the appearancce of pores. lt activates with just one point of contact, allowing for efficient care of wide-pored areas like the T-Zone and U-Zone.
The information above is intended to describe general technologies
MC Mode
MC mode cares for more volumized appearace in areas prone to sagging such as around the eyes, mouth.
The information above is intended to describe general technologies.
Derma Shot
Derma shot mode is optimized to target areas of the skin where more definition is neede. lt helps to provide more refreshed and defined-looking skin.
The information above is intended to describe general technologies.
Advantage analysis
Microcurrent and enhanced penetration technology are designed to address signs of aging such as sagging skin, wrinkles, and loss of elasticity, and to improve the absorption efficiency of skincare products.
Provide you with exquisite service

AIR SHOT MODE
Brush against dry skin 2-3 times a week (5 minutes per use) Use it on dry skin by sweeping the device head from the inside to the outside.Keep your movements gentle and at a steady pace, and avoid repeatedly pressing or lingering on the same area.

BOOSTER MODE
Absorb skincare using Booster Mode 1-3times (use 5-10 minutes per use) Use itafter applying skincare, and roll it on theskin in a circular motion from the insideto the outside.When used with a high-performance serum, Boostermode can enhance the effects.

MC MODE
Use 1-3 times a day, in an upward motionby adhering the head to the skin (5-10minutes per use) Use it after applyingskincare by pulling upward from theinside to the outside.When used with a cream, MC Mode enhances skinvolume.

DERMA SHOT MODE
Use 1-3 times daily, pausing for 1-2seconds on desired area (5-10 minutesper use) Slowly draw a circle or massageoutward to relax your muscles.When used with a cream, Derma Shot Mode boostsyour skin elasticity.
Its core, unique advantage is something other brands don't possess.
|   |
|
Others |
|---|---|---|
REP™ Dynamic Push-Pull Technology: Achieving Synergistic Anti-Aging from Within and Without |
||
Booster Hi-Penetration Technology: Focused on the ultimate optimization of "absorption efficiency" |
||
Specialized mode for oily/problem skin |
||
Unparalleled instant effects and user experience |
Questions? We’ve Got You Covered
Do I need a special gel when using Booster Pro, or how should I apply skincare products when using the different modes?
For Booster mode, apply a light serum or ampoule, followed by a thick cream or gel. Then use MC and Derma Shot Mode with any remaining product on the skin, adding more if needed.
I'm curious about the order of use. Can I use all 4 modes in the same routine?
Yes, all four modes can be used in one routine. Start with Air Shot on clean, dry skin before applying any skincare, then use Booster, MC, and Derma Shot with your regular skincare.
What is the usage cycle for each mode?
Be sure to check the usage cycle before use, and adjust the usage cycle and usage time according to your skin type.
How should I use skincare when using the booster, mc, and derma shot modes simultaneously?
Absorb a light serum and ampoule in booster mode, then follow with a rich, viscous cream/gel formulation. After booster mode care, use mc mode and derma shot mode with the remaining amount on the skin without applying additional skincare. If the intensity feels too low, add additional product. *The above usage method is suggested for simple understanding. Find the method that suits you best while using it.
Can all 4 modes be used around the eyes?
All four modes of Booster Pro can be used around the eyes, and we recommend using level 1 for areas with thin skin, such as around the eyes, nose, and mouth.
It’s too bright even when I close my eyes. The LED seems to be too strong. Is this okay?
It may feel too bright, but it has no effect on your eyes and is safe to use. However, if there is a lot of product on the head and the central LED operates even without contact with the skin, be careful of direct eye exposure. For your comfort, you can turn off the LED through the app if needed.
Is it defective if there are scratches on the device head?
We used surgical steel, which is commonly used in medical devices such as scalpels and syringe needles, for the device head. While it is non-allergenic and rust-resistant, slight scratches may occur during the manufacturing or cleaning process due to the characteristics of surgical steel.
Is it defective if there are scratches on the LED head?
The lines on the booster pro LED section are not scratches but marks formed during plastic production. It is safe to use and is not defective.